Search results for query: Cable route

So is 2.5mm Arctic cable or orange 2.5mm ehu cable both suitable for the ehu wiring? Am going to be routing cable from the SB area to under the drivers seat area at some point soon and want to put a cable in for ehu and am wondering what to buy

What’s stopping my cables from going from the tailgate grommet to the hinge grommet on the RHS? I’m trying to ad solar cable and wanted to run it across from one side to the other inside body work but it stops half way. I have Barn Doors

STEP 1 - PICK THE WHEEL I went with Steven at sscustomworks He does a huge range of customisation. I picked an all black with leather and alcantara. The wheel was £280 and controls £150. I re-used my own airbag/horn. I got a few free looms and used the white platic cable routing, but more on...

With great difficulty!! This pic maybe shows it the best The terminals on the inverter are right angle ones, the cables then loop from there along the outside back under the inverter mounting bracket, which has various holes in it - they then loop back again and enter the seat base at the...

How did you route your cables behind the inverter? I don't seem to have enough space between the rear corner of the battery and the side of the base to safely get the cables through. Simon

There are a series of bungs along the sill of my LWB, including one that comes up in front of the C pillar. There is a gap behind the C pillar to bring it up, which is the route I took for water and waste on mine. I needed a helper poking a cable through underneath whilst I tried to fish it out...

Load of different ways really. I wanted as low profile as possible (so didn't use a gland). I drilled and just used black silicone on top and underneath. Where I when through the roof it's at the back so not inside the poptop canvas (cables route through the OEM hole above the door seal...

When I did mine, I did run some cables from passenger side to rear to EXACTLY the location you want, for a light switch for my site/day van. But..... I've also fed cables from drivers side to the roof so I do know the route. (Pics below to help). Apologies in advance if some of this you know or...

I need to get cables from under drivers seat to the o/s rear quarter area - the upper half between C and D pillars. I can get to the bottom half from the O/S passenger panel then via the C pillar. There is then no route up into the upper area I need. Do I have to go right the way back, into...

Second this. I have a mental threshold of 30A - below that things are "everyday" and well within scope of good tidy DIY work, decent cable and easy crimp junctions. Above that you really need to think about routing, length, voltage drop and need more specialist heavy duty crimps and tools - if...

On March 4th, I routed and connected the cable to the alternative power source. Since then, I’ve driven the car for a little over 200 km, and everything seemed fine. However, since Monday, March 10th, the car has been sitting in the garage for two days without being used. I only checked a few...

Absolutely. This is a supported configuration. I have a similar setup, although my leisure battery (VW California) is an AGM battery. Presumably, your Leisure is charged by your alternator already? If so, when the car/alternator is running, the voltage seen by the Alternator Charger should...

Oh I will be reading replies with interest. I've bought the alternator charger but won't be fitting it myself. Have it booked into a place next week. Spoke with one of the guys working there about it and he said it would be grand connected to the direct live feed going to the LB. But his...

I’m going to start my big power upgrade soon so have been working out where to put all the bits before planing the cable routes. I’m going to fit my EcoFlow 800w charger and would like to know if attaching the power wire to my lithium leisure battery will be ok instead of taking it to the...

Due to an oversight on my part, I missed off the factory fit rear camera when I ordered my van. I recall asking for a retrofit install after delivery using the VW kit but didn’t as I wasn’t entirely comfortable with the reaction and approach to doing this so decided I’d fit one after delivery...

Rough out the route with a piece of string & take it from there, Better a yard too long than 6" short. Ultimately @Stay Frosty is correct. The only way to get it spot on is to make up the cables as required, if you're going down the pre-made route, be prepared to compromise.

Just looked back at my order history from 12v planet and I bought 3m of red and 3m of black 50A (6mm²) my DCDC is also under driver seat so I guess you'll be okay with the 3m kit? I've some left over that I used for other connections. Think I may have traced the route with some rope first to...

reviews: @Led Sandwich " Hey mate mine was fitted at halifax camper conversions. Overall its been pretty good. No leaks, wind noise etc. I had them carpet line as well and that was a nice job and handy to get it back all done. they even gave me a few m of extra fabric. I spent ages trying to...

I had similar and had to go direct to the head unit without going through a dash adapter:

Thankfully, we never got to see an itemised cost - it was just bundled-in with the cost of the conversion. :) We went this route because, when we'd previously hired a camper with the hook-up point under the rear bumper, we almost drove off with the EHU still attached. Luckily, as we set off, I...