Search results for query: *

Fitted a couple of storage nets and noticed no dodo mat in the rear doors, so using what I had left over from my front doors I did the rears . Also have put the wiring into the connector in the zip pocket (can't zip it back up does that matter!?) ready for the momentary lock button I'm putting...

* FREE (JUST PAY THE POSTAGE) * I bought these mats from VanMatsUK 2 weeks ago "made to measure". Long story short, they're a bit big! I complained, so they sent another set out....which again are too big. VanMatssUK have advised me that there are 4 templates for the T5/6/6.1 front mats in...

As above belting in the next size torx up after a good soak in penetration spray (oo-er) will likely do the trick. If not a bolt removal die kit is your next option in this line of attack. the rubber seal looks quite old? If it's lost its 'firmness' it might be that a a new door seal would...

Hi, ok this is what I did today. The files you requested are attached. I also followed your suggested procedure to the T. Before I carried out the tests this is what I did so you know the situation. I felt I needed to do this and also explain behaviour prior to carrying out the tests. Just so...

Welcome to the forum - pics of your van are required if you want help - pay the piper! :whistle: While there are many many general posts on this subject and while there are some who may feel you should be doing a search on setups... I have to say there is no harm in an updated opinions and...

Took it for a little run , washed it .....and found it's STILL got an oil leak :thumbsdown: ....belly pan off again tomorrow :rolleyes:

Congratulations on the new addition. Wondered why your build thread went quiet. You were building a family! Here's to many happy adventures.

Ooof... a full tank of premium!? Dare I ask how much that set you back? Happy 100k buddy!

All set up here too. Not put up awning. Cosying up for later, then pub for supper

All set up here too. Not put up awning. Cosying up, then pub for supper

Completed the packer install and also foil foamed the rest of the area cause it was spare and there... i know it's not essential to anything. Nice that the voids are filled is all. Got anchor points to drill out and loads more to do

Hi, This is my first post have been lurking the forums and digesting loads of great information. My question is would i be better off with a sargent set up or a victron type one? Mainly going to be off grid , intend to fit solar to roof and a lipo battery, opinions gratefully recieved, Thanks in...

I too connected my BLUETTI Charger 1 to the negative connector too and it drained my battery. Since connected to the headlight fixing point but still seeing slow drain on my battery while van not being used. I’ve installed a battery monitor and it charges fine while driving but lost 10% in 3...

Yes, apparently it’s because the front tyre flicks up the offending item and so it isn’t lying flat when the rear goes over it. Well they are different, so yes.

Re-positioned Fiamma rear bracket as the one fitted had broken rivets. I have moved the bracket back 17" to the rear. This will give better support to the awning ,as it has a roof fitted the only fixing was forward of the original roof fixing that is now taken up by the roof. I have drilled and...

Looks very smart. Not seen many options for a 3rd row bed. No seat belts?

Using a multimeter amps dc between vehicle battery negative and negative terminal

I could have made better use of the pitch and brought the van much further forward and put the camp shelter behind the awning. I also have a drive away Galli but not sure I really need it anymore! I prefer this setup.

No there isn't an ignition live on this, I believe it's automatic. Wired as per diagram.

How are you measuring the current drain?