Search results for query: water ingress

I have seen on here quite a few posts about getting water on the step with deeper aftermarket speakers. However I cant seem to find a definitive solution. Did anyone find one. I now have this problem, however strangely it only seems to be passenger side. Not only is the water in the...

...connections under the body of the van - especially leading to the Adblue control unit. VW dealer replaced this 3 months ago and its corroded again already. Does anyone know of any common places for water ingress, or if its possible to protect the underside more from spray off wet roads? Thanks!

Water can track anywhere unfortunately so really hard to determine the ingress point. Another dealer could look at it for you but really you need to give the original company fair chance to put right. Even though a large dealer, that doesnt equate to quality of work and often times a loss of...

...with recycled insulation (in the rear only). Still got sliding doors to do and tailgate but like fronts wont use insulation in case of water ingress from leaking things. Didnt do them at the time as am upgrading to antrhracite all round and was waiting for a good second hand set to turn...

Did it work previously? Is it mounted underneath the vehicle? Water ingress?. Corrosion? Fyi.... It's a very bad idea to put a fuse in a circuit higher than it's rated for. (Ie 10A in 7.5A ) Got any pics? Have you checked the fuse card in the download section to see what else is supplied...

Many thanks, yes, that would be so helpful- just concerned about too much water ingress. If you give me a shout when theyre done I'll paypal you the cost

Photos of nearside shaft

...reset.... https://www.t6forum.com/threads/full-van-ecu-reset-capacitive-discharge-how-i-done-it.13730/ ... If it's still doing it after that you will need it looking at .... Possible water ingress or corrosion. On or around switches or BCM. Eg water ingress on door panel window/lock...

Just been out to the van and it appears that I have a leak Opened the drivers door and the wheel arch lump by the accelerator pedal was wet, looks to be dripping out from behind the dash, putting my head up behind the obd port and it’s wet up there. Seems to be coming out of here where the...

...them lonways to give some additional support. i think the main issue is when people fully-seal-all-round which causes air pockets and water ingress that can heat-up in extreme weather and bubble up the panel . . . . . . im hoping by leaving the lower ridges open, and at the rear that this...

...blanks from Just Kampers. Top Tip! Don't over tighten them! They are not very strong and getting the thread out is a pita. Also put a small smear of silicon grease on the rubber prior to putting in the van, to prevent water ingress. Set of 4 External Roof Panel blanking bolt for VW T5 and T6

...is a T5.1 but the locking mechanism isn't the standard set up according to their parts diagram and catalogue so i'll try the @minmax89 suggestion / test first and look at the wiring loom after - we did have some water ingress as a result of the tailgate seal failing so that might explain. Thanks

So it all originated after a good old intensive wash... I expect there is a water ingress but want to have the right parts to fix prior to starting. Will pin back some photos when I get in about it later... it is intermittent so it says to me likely a issue with a cable or indeed sensor...

Used to have a works mondeo estate which was prone to the micro switch in the boot handle corroding through water ingress....

Interesting thread and great information from both of you, @General-Monty & @Dav-Tec. My 8" door speaker has failed from water ingress, albeit after about 3 years. I'd made a curved shroud out of sound deadening, stuck on the back side of the door frame, behind and over the speaker that worked...

Possible corrosion on one of the common earth points. caused by… water ingress? Maybe.. need to look up the earthing diagram, but 2 places off the top of head are; bulkhead behind the pedals and behind the dash clocks. There might be one high up above the courtesy lights. (Most likely)

Dreamy! This worked for me :) Thanks @Niknak !

Any idea how to pull the lower rear of the door closer to the body? Mine is not flush at all at the rear bottom, but is ok at front bottom, and ok along top edge.

Apologies if this has been asked before but in a slight flap, I’ve discovered the cab floor lining is damp and stinks like an old sock, I’m removing the upstand for the bulkhead and found it’s damp right behind the passenger bench seat, hopefully I will have attached a photo, any ideas?

Busy afternoon, bumper off yet again, swapped out one of the added DRL’s as it had water ingress, great customer service from Travelinelite, no quibbles replacement sent. Also fitted my recently bought VW Carbon splitter from @Jon , big thanks to @Bundy88 and @Jwardy23 who got it to me via the...