busbar

Can anyone advise please? I already have a t6 and Currently my items are protected as follows Dcdc 16mm2 50amp midi fuse Mppt 10mm2 30amp midi fuse Mains charger fuse internally. 6way fuse box 10mm2 50amp midi fuse 4way fuse box 10mm2 50amp midi fuse I'm doing up my T6.1 and planning on doing...

I am placing my non isolated DC charger under drivers seat using the under seat chassis ground. I am placing the leisure battery and fuse box in a cupboard behind the drivers seat. I want to limit how many cables I run from under the seat to the cupboard. Therefore if I use a bus bar under the...

Evening all, so I used a company called Nomadic energy to sort all my electric components out. You tell them what your loads will be etc and they send you the equipment and wiring diagrams. All seems good but I have been looking at the diagrams and have a question about it. They put the output...

Hi All, a simple admin Q really. My current set up is all wired direct to the battery. The new Lifepo has M8 screw terminals. Now, I did get some screw in posts and new post connectors which frankly are shocking quality and I wouldn't put them near a PP3 never mind a leisure batt! What is a...

Hi everyone, I'm choosing fuse boxes whilst waiting for my Roamer SB230 battery to trickle in. So, I understand the difference between the -ve busbar and -ve to body ground types of fuse boxes; clearly the one with -ve busbar is good for those places where the body is fibreglass or wood - ie...

Here is how I propose to wire my van. If anyone has a moment to take a look I would be very grateful if you spot I have made an error. Especially with cable sizes as there seems to be such variation in the advice. I have sized assuming the only two long run are the connection from the...

Hi, could anyone help me with this please? Is it ok to ground the leisure battery via a busbar which is grounded to the chassis? So i have a 16mm from the chassis to the neg busbar then a 16mm from the busbar to the neg of the leisure battery? Is this ok or would i be better with a 16mm...

Seat Base Electric + EHU + Solar Install + Charger + DC-DC -- How We Done it -- id like to build a thread showing what's possible as regards to seat base builds. lets post a collection of our electrical installs, be it in the seat base or rear conversion. just EHU or SCR/VSR, charger, DC-DC...

I’ve got 6 -ve cables I’m looking to fit onto a 4 post 100A bus bar. Do I need to use the same sort of calculation as I’d use for cable and fuse rating i.e. is the sum load under 100A. Or should I just get another busbar? Cheers, flo