firewall

  1. J

    cable routing

    Hello all, am looking to install the renogy dual dc charger under my drivers seat but need to get a cable from under the drivers seat to the fuse box of my t6.1. Any ideas of the best route, ideally under the floor, seems most logical , however that is rarely the case
  2. D

    Cables from engine to under seat- under gearstick

    Hello I am planning on running the EHU cable and the B-2-B cable from the engine bay through the grommet in the bulkhead. I would then like to use the cable run that is on the left hand side of the drivers footwell. I have looked at the instructions about lifting the rubber floor and can see...
  3. sipep

    240v cable separately from 12v (cable route)

    Hi all, I've had a little search in the forum but can't find my answer. Is there a secondly grommet other than the one behind the starter battery? I want to put my 240v hook under the bonnet but someone said mention that the 240v should be keep away from the 12v. I already have a 12v cable...
  4. M

    EHU cable-run in to cab area.

    Evening to the collective. Just a quick question. And yes I have searched Those of you with split charging and EHU under the bonnet, did you use the same hole through the passenger side grommet? I'm about to run my EHU hook up into the drivers side base but wanted to check if there was...
  5. nimrod

    getting cables through firewall

    Hi all, I am desperately trying to get a wire through to the battery area under the bonnet for a feed to a new 12v outlet and usb, these are being fitted in the rear area of my Kombi, the auto electrician is not interested/keen on using a piggy back fuse which is what I was going to do. I have 2...
  6. O

    T6.1 engine bay cable routing

    Morning. Apologies if this has been asked but tried searching and couldnt find what I was looking for. I’m adding a split charge system and need to get a cable to the engine bay. I’ve seen a vid on a T6 which seems to show an unused grommet under the glove box/next to the starter battery but...
  7. T

    Windscreen mositure at bottom of screen - where does it go?

    Hi I have a 16 Cali with comfort dash. I get a fair bit of moisture on the windscreen which is what I would expect in a camper that is being used. It's enough to use a squeegee at this time of year. Last weekend I just pushed all the moisture down to the bottom of the windscreen and it...
  8. WheelieBealie

    Footwell Trim Removal

    I'm trying to run the cabling for my BCBC charger I've just bought from @travelvolts but I've run into an issue straight away, how do I remove this plastic trim panel am I missing something as there's no hope of pulling the carpet back while this is in place! Glovebox is out and the end panel is...
  9. Cables Through Bulkhead

    Cables Through Bulkhead

  10. MartyMoose

    Engine bay cable route through bulkhead/firewall to cabin

    I'm looking to run a cable from the main battery into the cabin. Anyone know if there is an easy route through, maybe using an existing path, or do I have to think about drilling a new hole in the engine bay bulkhead (gulp). Any advice much appreciated.
Back
Top