3D parts for T6.1

[Psm1975]

I’m starting this thread off to show some of the 3D printed bits I’ve made for my 2022 T6.1.

If anyone has a 3D printer, I’ll happily send the files over for free. If you don’t have a 3D printer, but want any of the parts, they’re available on my Etsy page.

More information and measurements are on the Etsy ads.

https://www.etsy.com/uk/shop/PandEmCustom?ref=shop-header-name&listing_id=1662013584&from_page=listing

Hopefully somethings of use to you. If anyone has anything they think would be useful, let me know and I can sketch it up.

 

[Psm1975]

This is a swivel to enable the fresh / waste water lids to be screwed on and off without twisting up the pipes / cables

 

[Psm1975]

This is a hinge for the VanFurniture tables. I found that when I stored the table behind the drivers seat, the leg stabbed me in the back through the seat. My solution was this hinge which allows tue table leg to be folded in half
.

 

[Psm1975]

This is a flip over cover for a 12v dimmer switch. It locks open, but when sleeping, it locks shut preventing a very unassuming light from blinding me during my sleep

 

[Psm1975]

Similar to the last item, this is a cover for the laverna Pro CDH control unit. Available either top of bottom hinged.

 

[Psm1975]

I didn’t want a full size gas bottle, so made this bracket to utilise the 220g butane Cartridges.

Please note that a Carbon Monoxide sensor won’t detect leaking gas. Ensure you always fit a gas sensor when using gas in a confined space.

Link to regulator: https://amzn.eu/d/i5Hjr1q