ABS / wheel speed sensor fault after finishing project

[smokey80]

Hi Folks

I’ve had the van off the road for the past 6 weeks re-doing the kitchen units, rear sound system, running wires for the reverse camera. I’ve read a few threads regarding abs faults. Basically no issues before then I have error code C101D4A, C101A07, C101B07, C101C07, C101D14, C101D29. All ABS and wheel speed sensor issues. I’m worried I’ve hit a wire or connect box somewhere. Where would be the best place to start looking?

The Van is T28 T6 2016 Bluemotion, Pop top etc.

Thanks in advance for any advice

 

[JoshB_]

If you’ve been doing wiring, I’m assuming you’ve had the battery disconnected?
Have you took it for a drive yet? The steering wheel needs to go lock to lock when you first reconnect the battery and all the faults “should” go away.

 

[smokey80]

Ahh right that’s great, I’ll try that Josh thanks very much. I was hoping I hadn’t nicked a wire somewhere, but yes I’ve had a the battery off for a while.

 

[smokey80]

Do you know if you need to actually drive Josh? Just quickly when outside and started it and went lock to lock but ABS light still on? Is it worth taking it for drive tomorrow?

 

[JoshB_]

When I had my battery off and got the plethora of warning lights, nearly all cleared going lock to lock with the steering wheel.
Only one that remained was a wheel speed sensor, which then cleared as soon as I pulled off the drive. Best one was the wipers not working, had a right meltdown and I'd just not shut the bonnet properly!

Hope yours gets sorted.

 

[JDC]

I've the same warning lights and codes but not had the battery disconnected. I'll try the lock to lock thing before my brother replaces all 4 senors and pads at the weekend.

 

[smokey80]

When I had my battery off and got the plethora of warning lights, nearly all cleared going lock to lock with the steering wheel.
Only one that remained was a wheel speed sensor, which then cleared as soon as I pulled off the drive. Best one was the wipers not working, had a right meltdown and I'd just not shut the bonnet properly!

Hope yours gets sorted.

Thanks Josh

 

[smokey80]

I've the same warning lights and codes but not had the battery disconnected. I'll try the lock to lock thing before my brother replaces all 4 senors and pads at the weekend.

Yeah sorted it tonight, basically there was a repair on some wires on the passenger side B pilar that needed some attention. After that and a quick drive she fixed again

Thanks for the help guys