Sold As new 2+1 in Brick Fabric. £1600

[DubDavid]

Immaculate (as new) set of 2+1 Kombi seats in Brick fabric. 2 bench seats on driver side and individual seat with easy entry on the passenger side. In Brick fabric. I'm selling with all of the floor mounts and seat belts.

As these are 'as new' the price is £1,600

These were removed from my brand new (24 plate with only delivery miles) T6.1 SWB Kombi with Tailgate and 1 sliding door on passenger side as has gone straight in to be converted.

If you would like, for an additional cost, I can also sell the rubber floor mat and lashing points (I'll not sell these separately until the seats are sold in case whoever buys the seats wants the lot).

Collection from Exeter.

Thanks

 

[DubDavid]

Update: Reduced to £1,600. Thanks.

 

[nigelcro]

Question...

Are the fittings for these present in all vans, or would I have to get new fittings installed on the floor? I presently have the three across rear seats. I could probably get the mat lifted and take a look, but that would take some work and it is brass monkeys out there right now...

 

[DubDavid]

Hi @nigelcro, If you have the 3 seats that are all one bench then I think the floor mounts are different to the 2+1. I'm selling this with the floor mounts that these 2+1 seats clip into, and seatbelts, but don't know how they attach to the floor (I didn't remove them). I can also sell separately the rubber matt that has the right cut-outs for these seats.

 

[nigelcro]

The floor mounts are deffo different - the three seater only has four fixings in the centre.

I would very much like a 2+1 in the back, it would help me with access to the dog crates and associated stuff. But I need to know if I have to start cutting holes in the floor and drilling into chassis members etc, which might be a bridge too far for me to do as a DIY project, thus increasing the cost of the change over considerably.

I am hoping that someone will be along later with the answer.

 

[Phil1878]

The floor mounts are deffo different - the three seater only has four fixings in the centre.

I would very much like a 2+1 in the back, it would help me with access to the dog crates and associated stuff. But I need to know if I have to start cutting holes in the floor and drilling into chassis members etc, which might be a bridge too far for me to do as a DIY project, thus increasing the cost of the change over considerably.

I am hoping that someone will be along later with the answer.

Their the same bracket, there's just more of them in different positions. If you go ahead and get this I'm after 4 brackets...... just saying

 

[Chippie1]

I’ve just had 2+1 fitted to my panel van the holes are marked on the skin of the floor for all variety’s of seat positions you just need to decide which ones then drill pilot holes and bolt through to underside of van

 

[DubDavid]

Thanks @Chippie1 and @Phil1878 that's really helpful.

@nigelcro please let me know if you have any more questions or need more info. Thanks for your interest.

 

[nigelcro]

Thanks guys - I will spend some time on YouTube see if I can get an idea of what it all entails.