LambethBoy

204 DSG 4Motion
VCDS User
VIP Member
T6 Pro
Well I read the very long thread about retrofitting factory LEDs and I would just like it simplified please.
If I get my paws on a set of genuine leds what else will I need? I'm not bothered about the washers on the bumpers.
Is it just headlights, motors and coding?
TIA
 
The main components are
2 x led headlights
2 x main headlight power modules
2 x DRL power modules
2 x level sensors for front and rear axle
1 x levelling control module

There are several smaller bits that go with it like replacement dash dial (so you dont fail MOT) nut/bolt for front level sensor, plugs/connectors etc etc then the wiring that runs between it all
 
The main components are
2 x led headlights
2 x main headlight power modules
2 x DRL power modules
2 x level sensors for front and rear axle
1 x levelling control module

There are several smaller bits that go with it like replacement dash dial (so you dont fail MOT) nut/bolt for front level sensor, plugs/connectors etc etc then the wiring that runs between it all

Thanks Pauly! Thats just what I needed mate!

Sorry, just to check......these items are different to the ones already fitted to my T6 with H4 units?
 
Sorry, just to check......these items are different to the ones already fitted to my T6 with H4 units?

Going by what @Robert has done, I’d say so (after reading your other post about a H7 project, you’re probably aware) (I’ve added eBay prices to the original post on order to give a rough idea of cost - approx £1800 all in):

AmountPart NumberItemCost
17E2941035 / 7E2941773LHS LED headlamp£570
17E2941036 / 7E2941774RHS LED headlamp£570
24G0907697G / Fpower module for sidelights/DRLs£60 / £60
27PP941571A / AE / ACpower module for low/main beam£70 / £70
14N107086014x14 hex flat-head bolt for affixing modules to headlamp (7 + 4 each side)£9 / £9
21J097373714-pin headlamp plug including rubber seals & terminals£7 / £7
16R0907357Cheadlight range control module (HRCM)£93
17M3972726plug for headlight range control module£9
1000979025Epre-crimped wire (with terminal at each end) for side lights connection to the BCM£5
10000979009Epre-crimped wire (with terminals) for PWM connection to the BCM & HRCM plug£12
16Q0941334illumination adjuster£19
17E0941273front level sensor£118
17E0941274rear level sensor£118
24B0973712Aplug for level sensor including rubber seals & terminals£6 / £6
-15m x cable 6 x 0.5mm2
 
I am also keen to do this upgrade at some point. Currently have to drive with front fogs on at night just to see where I am going.
 
Going by what @Robert has done, I’d say so (after reading your other post about a H7 project, you’re probably aware) (I’ve added eBay prices to the original post on order to give a rough idea of cost - approx £1800 all in):

AmountPart NumberItemCost
17E2941035 / 7E2941773LHS LED headlamp£570
17E2941036 / 7E2941774RHS LED headlamp£570
24G0907697G / Fpower module for sidelights/DRLs£60 / £60
27PP941571A / AE / ACpower module for low/main beam£70 / £70
14N107086014x14 hex flat-head bolt for affixing modules to headlamp (7 + 4 each side)£9 / £9
21J097373714-pin headlamp plug including rubber seals & terminals£7 / £7
16R0907357Cheadlight range control module (HRCM)£93
17M3972726plug for headlight range control module£9
1000979025Epre-crimped wire (with terminal at each end) for side lights connection to the BCM£5
10000979009Epre-crimped wire (with terminals) for PWM connection to the BCM & HRCM plug£12
16Q0941334illumination adjuster£19
17E0941273front level sensor£118
17E0941274rear level sensor£118
24B0973712Aplug for level sensor including rubber seals & terminals£6 / £6
-15m x cable 6 x 0.5mm2
There's a nearside LED headlamp for sale on eBay for £290:

and an offside for £350:
 
There's a nearside LED headlamp for sale on eBay for £290:

and an offside for £350:
Just carrying on from this. Make sure that the units have RHD on them for Right Hand Drive vans otherwise your beam pattern will be off. IMG_8530.jpeg
 
Back
Top