Kombi Conversion - Seatbelt Measurement Please?

[Adam_T6]

Hello,

Is anybody in the position to measure this distance, but on the drivers side please?

 

[VanDamMan]

Hi...if that’s the C pillar .....a rough guide is 94 cm....but I’m sure you should see the anchor points unless they are blanked out

 

[Deaky]

All the info required is in this thread Panel van to Kombi

 

[Adam_T6]

It is the C pillar, for some reason I have the threaded plate on the nearside but not the offside.

Is there any chance of a photo?

 

[VanDamMan]

. Try 96 cm

 

[Adam_T6]

All the info required is in this thread Panel van to Kombi

This only shows the nearside measurement, the offside can’t be measured in the same way.

Nearside (255mm down from datum):

Offside:

 

[Deaky]

This only shows the nearside and the offside is different?

Wonder why? You’d think the seat belts would be at the same height

 

[Adam_T6]

Wonder why? You’d think the seat belts would be at the same height

I’ve reworded that, I guess they’re the same height but there’s no ‘datum’ on the offside..

 

[VanDamMan]

Hi. This might sound daft but in you first photo ...at 32cm it’s next to a hole for the trim button from that point to the top anchor bolts its about 37 cm( same on both sides)

crazy but might help

 

[Deaky]

I’ve reworded that, I guess they’re the same height but there’s no ‘datum’ on the offside..

Why can’t you measure down from the datum on the near side and mark it then measure from the floor to the mark and transpose it over to the offside?

 

[Adam_T6]

Thanks for the help all. I think this measurement varies depending on whether you have a sliding door, for future reference:

SWB single sliding door - 64.5cm


LWB dual sliding door- 68.5cm