New to the forum and I’ve searched for anything useful but couldn’t find hence the question. I have a switch XL and have just been away in the highlands for a couple of weeks. I have the forty winks mattress and I found that in the morning when i went to move my duvet and fold up the bed etc, I’m just not getting the right technique to quickly fold up the switch etc. With the mattress folded up, regardless of where I put it unless on the floor just behind the drivers seat, it was tough to fold the switch back up due to the weight of the mattress. With it being -8 ish I wasn’t for putting it out of the van etc but it’s not something i could get right/quick to get it away to move on with the morning etc. Anyone else have the same issue/got a good, fast way of sorting?
Ovano Switch bed advice
- Thread starter MW2025
- Start date
@Josh (OVANO) might be able to help
Hey there,
The easiest way to fold the bed up is to start with the mattress. Fold up so that its sat on top of the bulkhead section only. At which point you should be able to lift the two smaller top panels that become uprights and push the bulkhead panel back at the same time. just to confirm you need to ensure that the weight of the mattress isnt on top of the two folding panels otherwise you'll be working against the weight. When you get the technique it should take less than 20 seconds to fold the mattress and revert from bed to mini bulkhead.
If you still can't get it please contact us via phone or email and I'll run you through it.
01275 261012
[email protected]
Cheers,
Josh
Similar threads
