Removing Charge Air Cooler to reach glow plugs

[jesteh]

I am trying to replace glow plugs (slowly) but to reach them I have to remove Charge Air Cooler.
Any advice how to do that, I assume that I have to clamp the hoses before removing, remove the screws and done? When putting back , I just pop them back on, top up the coolant and start the engine for a bit. Anything else like bleeding the coolant system after?

 

[Dellmassive]

clamp off the coolant hoses to limit loss,

remove, then refit.

coolant system top up and bleep procedure will need doing via vcds or other,

ie run pumps in order to bleed.


various item in the download section.

Downloads

www.t6forum.com

VIP Membership

VIP Membership Information

www.t6forum.com

.

 

[jesteh]

Thanks, thats the sort of instructions I was after
Now I just need to fill in the fine detail so I joined as VIP member first.
Found instructions for glow plug removal, but I kind of knew that part.
Can't seem to find anything for bleed / prime procedure on coolant. is there a how-to I am missing?