Solar Panels on a Westdubs Roof – Anyone Done It?

[pete_d]

Has anyone fitted solar panels to a Westdubs roof? I'd really appreciate seeing any photos of how you've gone about it.


I've got a few ideas myself, but the ridges on the roof don't quite line up with the panels I have. I also spoke with a Sika engineer who advised against using their adhesives in the valleys, as they're not designed for areas where water might sit.


Would love to see how others have tackled this – thanks in advance!

 

[borat]

Yes, but was done by converters. I’ll see if I can take a pic tomorrow

 

[pete_d]

Yes, but was done by converters. I’ll see if I can take a pic tomorrow

That would be great, looking forward to seeing them.

 

[Absolut5]

Has anyone fitted solar panels to a Westdubs roof? I'd really appreciate seeing any photos of how you've gone about it.


I've got a few ideas myself, but the ridges on the roof don't quite line up with the panels I have. I also spoke with a Sika engineer who advised against using their adhesives in the valleys, as they're not designed for areas where water might sit.


Would love to see how others have tackled this – thanks in advance!

Post up a pic of the panel sat on the roof so we can see how it sits

 

[pete_d]

Excuse the state of the roof – we were down in Weymouth at the weekend and a couple of seagulls clearly took a liking to it!

I’ve just laid this panel on the roof for the photos, and I was actually surprised how little the curve shows – up until now, I’d only worked it out on paper.

The panel’s in landscape across the roof, and I’ve got three of these to install in total.

I’ve picked up some Sikaflex 252 for the job (but open to better options if anyone has recommendations).

What are people’s thoughts on installing it as-is? (Obviously I’ll be doing proper prep and giving the roof a good clean beforehand.) I'm thinking run four beads – one along each edge and one on top of each ridge. I’d prefer to avoid a full perimeter bead as I’d like some airflow underneath to help regulate the panels temperature.

Or is this not a good idea at all? Any advice or tips appreciated.

 

[borat]

Here’s how it’s done on mine

 

[pete_d]

Thank you @borat

 

[Absolut5]

Excuse the state of the roof – we were down in Weymouth at the weekend and a couple of seagulls clearly took a liking to it!

I’ve just laid this panel on the roof for the photos, and I was actually surprised how little the curve shows – up until now, I’d only worked it out on paper.

The panel’s in portrait across the roof, and I’ve got three of these to install in total.

I’ve picked up some Sikaflex 252 for the job (but open to better options if anyone has recommendations).

What are people’s thoughts on installing it as-is? (Obviously I’ll be doing proper prep and giving the roof a good clean beforehand.) I'm thinking run four beads – one along each edge and one on top of each ridge. I’d prefer to avoid a full perimeter bead as I’d like some airflow underneath to help regulate the panels temperature.

Or is this not a good idea at all? Any advice or tips appreciated.View attachment 284079View attachment 284080

I would swap it round so the wiring is at the back, run a bead of bonding down both sides around a inch in from the edge, and on the ridges , this will let some air under the panel to help cooling

 

[pete_d]

Thanks. But I want to put 3 panels up there. So needs to go landscape. If I rotate it I would only get one maybe two.

 

[Absolut5]

What wattage are they ?

 

[pete_d]

100 each.