I have the glowpluglightflashing and the other symbol which I think is the exhaust system indicator according to the manual. See below image. The glowplugflashinglight turns on after approximately 1 minute. Van starts no problem and runs OK seemingly. Any advice or pointers. Van was...
Hi all, my 2019 T6 has an intermittent stop/start fault. When I stop at traffic lights the glowpluglight flashes for a few seconds, then the van cuts out completely and I have to manually restart it. This doesn't seem to happen immediately, only once the stop/start has been activated for a...
Hi all first post had 2013 van for year no issues then started getting flashingglowpluglight and loss of power on acceleration turn off it clears until you accelerate hard again and another code I'd showing all the time and won't clear. Thanks in advance
Have the exact same thing it seems. Unfortunately it’s a bloody nightmare. I’ve had various sensors done oil regulator done twice. Oil pump. New battery. Still no further forward.
VW droitwich have never come across this apparently which I find hard to believe as so many have this issue. Good...
So you did not have the cruise control before??
The engine was ignition on only - but not running?
Please post a screenshot of where you are doing the changes.
What's the fault code in engine?
Just replaced intake manifold (genuine) due to swirl flaps stuck. After putting it all back together and running it down the road it seemed fine. Set off up hill and went flat out and the glowpluglight started flashing and vehicle went into limp mode, recycled the ignition and full power...
Mmmmm that is indeed how it feels.
But I can still roll along at 60-65mph on the flat.... but wouldn't be able to overtake anything.
I do still the flashingglowpluglight.... which I always thought meant it was in limp mode.
Dunc
Hi All,
First time poster here so please bare with me and apologies for any ignorance in advance. Appreciate any thoughts/insights anyone can offer.
I am looking for some advice on the likely state of my fuel system after uncovering a plethora of issues and fault codes.
Purchased my T6.1 LWB...
I don't but since the van wouldn't start and the glowpluglight was flashing plus that was the only one that wouldn't clear it seems the most likely candidate.
Hi guys getting this fault code and van feels down on power. Fitted a new MAF sensor and MAP sensor and it’s still happening.
I also had DPF light come on at one point and also had glowpluglightflashing a few times.
Any ideas? Thanks
Hi, It's a 204 cxeb,61,000 miles, 2018. Recently it seemed strange that when turning the ignition on to start you could let go of the key and it would then start a couple of seconds later. I had a Nox sensor fitted around 3 months ago after the engine management light came on. The engine...
Hi,
I have a 2109 T6 150bhp Highline converted from new by Nomad and new to me 1 year ago.
I had some glowplugs replaced last week at the garage and the next day when I tried to start the van the starter battery was too low to crank. It was new last year (AGM) as was the alternator and...
I had flashingglowpluglight that only occurred on cold start. VCDS shows oil pressure switch, but it failed the VCDS test of the oil pressure changeover valve as shown in a thread by mmi.
Both oil pressure switches changed by garage at their insistence failed to solve it and a subsequent...
I have heard this, but no way of knowing if the previous garage did this and cant find anywhere on Carista to check. I did get a DPF light, flashingglowplug and MIL fault shortly after purchase though and took it to a garage for diagnostics/remediation. They did forced regen and reset the...
Just bit of info I e been having turbo underboost codes come up and flashingglowplug warning light
Stipped intercooler out after noticing damp patch on front pictures are of the rear when stripped out
Just might help others with issue
I have a similar issue and have code P2463.
I’m waiting for the arrival of a Carly OBD scanner which I think allows me to force a regen…
But I’m wondering if the DPF is blocked… why don’t I get the DPF light showing on my dash and instead get the flashingglowpluglight and P2463 error code...
Hi all, Had a flashingglowpluglight intermittent over the past few days, Then that and the engine light today.
Fault now found and fixed.
The code was -
PO18300 -
FUEL TEMP SENSOR A - CIRCUIT HIGH
I thought it was the sensor but on further investigation found a corroded / broken wire just...
Hey all...
So my DPF is now critically full (soot close to 60g, oil ash 85g).
The glowpluglight is flashing and the engine management light is on. Significant loss of power.
I can't force a regen... I think the DPF is now too full and I guess the flashingglowpluglight is preventing the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.