Search results for query: grommet

I had this problem on one of my T5's and it was the rubber grommet for the hole for the sliding door motor which my van didn't have, new bung and some sealant sorted it.

...for the fresh and grey water, and fittings/clamps etc. I went for the 16l one with the premium pump and integrated lid which has the rubber grommet for the wire and a one way valve for air, and fittings for the 10mm fresh water hose. £95 all in. Really good quality thick grey and fresh...

Set of SWB roof bars (made by Omtec). Few years old but only fitted for 1 of those, been in the garage since. Odd mark from normal usage but great condition. Comes with all mounting feet, spacers, bolts and blanking grommets. £35 collect from Wolverhampton area.

...tweeter wires in the pillars. door speakers were housed on vauxhall collars, plugs chopped off, wires routed through the window regulator grommet and already were corroded. wires were twisted with no proper connection ti on or solder joint , used coax speakers ! they broke the clip holders...

Yeah that is of slight concern. I think regs is 2m and I’m at about 3 ish. But it’s through grommets, and routed through channels so minimal chance of rub and nowhere it can be trapped or cut. FYI I’ve just stripped the cab out for another issue and the 240 cable is as new. It routes out of the...

Will take a look does this mean lifting the seat or getting under the van It doesn’t feel like a draft it is more like a cold bridge I can’t feel any sort of draft it’s more radiant cold off the seat base That’s why I think it’s cold bridge? But anything worth a try is there only one point...

There are wiring grommets under the seat under the flooring, is it possible that one of those has fallen out?

...or inside. So here's what I did as temp and then permanent fix. Temp fix - on inside just above the latch in centre of tailgate is a rubber grommet. Remove to expose latch mechanism. You will see the latch bar. Pull this up to open the door. Close door, drive home. The actuator may unlatch it...

...from being the light switch. Dead easy At this point I was feeling good about the job and preceded to run the new wire to the E box through a grommet in the bulkhead on the drivers side and across the engine bay to the passenger side, all neat and tidy cable ties along the way. Battery out...

...are some possible adjustments down there. Also check all the various bolts are tight - I found a couple of loose ones. On mine there was a grommet popped out where the locking lever went through a frame. I still have a couple more squeaks to track down though. Battery - if this is original...

Thanks Sipep. Anybody else know if there is any advantage to using the grommet behind the air box rather than the one behind the battery for cable entry to run to under the drivers seat, is their channels under the rubber mat this side of van.

The thing to watch with that cable is in general it must be protected from UV - there seems to have been a trend for using it outside as either a SWA-lite or "armoured artic" and it's not suitable for either as the clear jacket will quickly harden and crack. They're specifically made as control...

I can't really advise you. But you can have a look what I have done, no, the cable is not near the pedal, comes out at steering wheel height and I've used a nature groove in the body work

...from my solar controller which is under my driver's seat to under the bonnet so I can connect my portable solar panel. Would this be better a route to use rather than the grommet behind the battery on my 6.1. Also were does it come out in the van, I am guessing it must be very close to the...

There is also a grommet near the airbox

Looks perfect but too late for me now haha

Has anyone thought of using this protected cable? It should be rugged enough to use in any location provided holes through steel are grommeted.

For those that might be interested there is a second grommet. Just look for a route of least resistance. There is also a nice grove which naturally holds the cable (test fitting only, but would secure it )

I like this, I'll brave the cold tomorrow and see if there is a grommet on the driver side

Hi all, I've had a little search in the forum but can't find my answer. Is there a secondly grommet other than the one behind the starter battery? I want to put my 240v hook under the bonnet but someone said mention that the 240v should be keep away from the 12v. I already have a 12v cable...