Search results for query: cable under passenger seat

So I think I've bought all I need for this now, then realised again that I don't understand electrics properly. I'll have two lights (total of six) on each dimmable switch/button. In trying to avoid voltage drop and wire issues, I was going to ground to the chassis local to the LED lights...

So after my solo T6 Spring camp:) I came away with four mods: strip lights on pop top, usb on VW badge, diffuser on exposed led strip and this one: Last year threw the orange "light of death" fridge out and replaced it with a chest fridge. In the camp discovered the 12v cable was long enough...

Hello Although iv read so many posts on all the leisure electrics set ups, my mind has “frozen” trying to work out what gear I need to order. So far, I’ve chosen a Roamer 160ah lithium battery,, to be fitted under passenger swivel. Hopefully some other Victron kit can fit in with this battery...

Hi, I'm new to the forum and have a question regarding my 2022 T6.1 Kombi. Under the single N/S passenger seat of a RHD Kombi is a long slim fuse box. This is fed by a fairly thick red wire which is permanently live and terminates and splits into a slightly thinner one and three thin ones which...

Update: I've wired the seats in using a combination of the above wiring diagram and the T6.1 heated seats diagram found in the VIP section and I still can't get them to work. As per the pic in post #6, I connected the wires under the passenger seat as follows: VAN - SEAT white -...

If you take out VIP Membership then you will have access to the wiring diagrams in the download section. It may be that it's not a bypass that you have fitted but the older design universal wiring kit that takes power direct from the lights? If you take a few pictures of what you have will...

Hi thanks for the reply. I have a permanent live under the passenger seat so was going to use that But will later on be putting a EHU cable in and another permanent live for a sub. Through that route.

That's correct - if you check the instructions it says to connect the MPPT to the battery first so it can detect the voltage. You can also set all the settings via the app at that point. You can also wire in the PV cables without a panel connected, at the same time as the battery cables. Then...

Thanks for this info. Appreciate you taking time to feedback on your outcome . I fitted a driver swivel yesterday (RIB) into our t6.1 shuttle. Plan was to also install the Kiravans double swivel on the passenger side as have double bench seat and the new style Kiravans double swivel has the...

more bits inbound thanks to 12v Planet + Screwfix. thinking of going with the external EHU IN under the bonnet by the battery . . . got some 2.5mm 20A Arctic blue cables for the runs. . . a two way CU . . . . ( the red lamp show incoming reverse polarity L/N apparently) which...

It is this wire… 4 AWG CCA Power and Earth cable I have one of these fuses in the engine bay approx 10cm from battery, then some of this wire to under passenger seat, then another one of those fuses, then across with this wire to the alternator input on the Renogy under driver seat. If...

make sure all those RED battery POS cables are fused as well . . . . you should have one MIDI fuse under the passenger seat, and THREE MIDI fuses under the drivers seat . . . ++++++++++++ can see from the pic angles if all you cables are fused. ++++++++++++ example...

Hi, I am in the process of converting my T6 .1 startline LWB transporter (2021) into a day van. While checking out conversion companies, I saw MSCraft's twin sliding base, which I like. I asked the guy who demonstrated the seat to us about the under-seat wiring and what, if any, coding...

2011 t5.1 problem ! Had towbar removed as it was in for accident repair. Handed me back the towbar and they've cut the wires from the socket. Attached photo of the cable that they've taped up which has a 3wire plug connected ( I removed the tape to expose the wires) Also removed the exhaust...

@roadtripper and @mmi I have been fiddling about today with attempting to get the pin 10 ignition live to work. To clarify I have:- OEM towbar & 13 pin electrics VCDS (& have made the adjustment to pin 10 active) a requirement for ignition live under passenger seat My question is, which is...

Thanks :thumbsup::thumbsup:

ok time to pre build some of thei kit. . . the idea is to pre-do as much as possible, then when i have the chance to install it. - maybe at next weekends bank holiday weekender. we will be camping - but may have the chance to do some install nbits. starting with the main starter battery...

Hi I’ve got the same question - can I use these existing cables under the double passenger seat on a new T6.1 panel van to charge a leisure battery through a DC DC converter? Are they a standard fit to provide a feed to an OEM leisure battery?

@Bigsidavies the original battery was a 110Ah standard lead acid, which soon proved to be inadequate so was replaced with the 2 110Ah AGM Leisure batteries, one under the drivers seat, in place of the original and the other under the passenger captain seat. Both connecting + and - cables (I...

Could you get the 460 s4 Roamer where my 230 upright is on the floor in the back wardrobe cupboard under a false floor? You'd soon sell a spare 230 SB... There's certainly space with your new inverter on its end..? That'd keep the Mrs happy with her hairdryer and kettle!