We are off to…… I don’t actually know…. Somewhere in Europe… next weekend. My T6 4motion normally wears 235/65/17 General Grabber AT3 because they look cool and the council owned country parks round here have some pretty extreme terrain . But the spare is a 215/60/17. If I got a puncher and put...
Hi Guys, hoping for a bit of advice regarding 4 wheel alignment following having had fitted @CRS Performance a set of KW STX coilovers, today i took van into local Hunter 4wheel alignment place, front camber is out both sides but more on drivers (sorry no printout) castor bang on toe needs...
Time to sell up. Two new toys arriving on the drive so this one has to go. Huge spec and unique custom conversion carried out to the highest standards by Bognor Motors and Slidepods.
Too much to list but here's a start
2017 T6 T32 LWB 204 4MOTION DSG Kombi twin slider highline in stunning and...
Well thats an intersting start here .... just as the title states ....
so my 15plate T5.1 has a knackered DSG box, n/s stub axle moves up/down, massive clonk/bang out of park etc ... vibration in high gear at low speed .. swishing sound from a dry n/s diff bearing...
I couldn't find the same...
Hi all, newbie to the forum but have been lurking for a while and seems a very helpful place. Just bought a 2017 kombi and am a first time T6 owner so nothing to benchmark against. It vibrates and resonates quite a bit at low revs when pulling away and also seems to do the same at certain...
2015 t6 kombi, highline, sportline
T30
180hp engine, euro5 engine so no adblue (has latest rev of egr cooler, uses no oil or water)
Dsg with 4motion
Twin sliding doors
93800 miles
Full service history (not vw since my ownership) just serviced including dsg and haldex
Mot until 30th January 2023...
4Motion Adaptation channel - MAS06098-Acoustic measure wiring logic
STANDARD / INCREASED TRACTION / REDUCED NOISES
T6/T6.1 Haldex clutch has an adaptation channel which presumably changes clutch clamping behaviour. The channel can be tweaked with various tools.
Conditions for the measurements...
I've got errors from my haldex pump so I've bought an oil, filter and pump kit to swap all of this for new.
Just had a look under the van and was wondering if anyone has any tips to disconnect the plug for the existing pump?
The wiring goes up over the haldex unit so getting to the plug seems...
2021 VW T6.1 4motion Transporter T32 150bhp
Manual 6 speed
SWB
14,600 miles ( will increase slightly as still in use)
2 years warranty remaining
Just had first service (07/05/22) at Listers VW Droitwich (£250)
Ascot grey
2-1 Kombi seating titanium black
Tow bar with electrics...
Registered 30/11/2017
Private reg not included in sale - is now on the original '67' plate
Totally clean MOT history with no advisories
T32 Kombi Highline 2.0l diesel 204PS
Four wheel drive / 7 speed DSG gearbox
MOT 10th April 2023
28k miles
1 former keeper
Spec:
Rear diff lock
Twin...
Hi!,
I was changing the rear springs on my t6 syncro and while shoving the trailing arm down to pop my spring out, there was a "clonk" and the driveshaft seems to have popped out of the diff slightly causing some gear oil to leak out (only a few drips)
Does this just "shove" back in?
Hi, very new to your forum so good to meet you.
I am looking for a quality T6 Caravelle and have come across an example I like the look of however it’s got 4motion. Does anyone have any experience of 4motion models over 2 WD? Are they more prone to failure? Expensive to own? Better to drive...
Anyone got a picture of the 4motion handbrake mounting in front of the diff? I'm removing my handbrake brackets to mount the diff and need to replace them with the 4motion abutment plate.
Hello,
I've got a 2017 T6 4 Motion and I want to convert it to a petrol engine, anyone out there willing to do / know anyone that would do?
Cheers
John
Hi all,
I've had a good search around on here and elsewhere but I can't seem to find any info on how to remove a rear driveshaft from my T5.1 4motion to allow for wheel bearing replacement. I thought this would be within my DIY capability so I've bought the new bearing and bearing tool but I'm...
Ok so i have previously converted 2WD vans and have used the CAK skirt tanks and also the triangle one in front of axel, have also used the one that goes around the spare wheel, but those wont work with 4 motion.
So i can still use the skirt tanks but what have you done for another tank?? there...
Hi All, I had a search but can't find anything. I'm going to be fitting a 3 seat bench in the third row position on our SWB 4Motion kombi. It seems the fitting points are above the rear diff, has anyone had any experience of this? Is it still straightforward or an absolute pain? From a quick...
I'm back (nearly) after selling my Reflex T6.
It was time to have a new van built, so I spoke to Oli at @BognorMotors :thumbsup:
After a few days of consideration, which in reality was about a year in my head, we came up with this T6.1 fortana red - Project Large.
Starting point was to pick...
Hi I have a brand new T32 Kombi 4M 204 SWB and I'm looking at lowering keeping factory 17 Devonports with springs only.
Has anyone done this and can comment on ride quality? I don't carry much unless we go away camping.....I'm thinking lowering 40mm max.
Any other advice appreciated.
Cheers...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.