Afternoon, trying to tidy up my t6.
Looking.for a rear bumper to replace my sprayed original which is a bit tatty.
Loads of Savannah blue but no ocean blue.
If anyone has one for sale please get in touch
Hi all,
My brother is going for the swamper look and is in need of a textured rear bumper without PDC holes.
Does anyone have one they would like to sell?
Cheers
Phill.
I have a crack in my rear bumper on t6 thats about 20-30cm long running into the rear parking sensor hole. Been to a few local bodyshops who said they wouldn’t repair and would only replace the bumper in full.
Question is could this be repaired and likely cost? And any recommendations for place...
Afternoon all!!
I’m moving on my old rear lights as I’ve changed over to THQ LED ones.
As per the title. No cracks or marks. Full working order.
With LED Reverse bulbs = 955 / 921 Twenty20 Impact Canbus LED 12V W16W which make a huge difference.
Fully understand there won’t be a huge...
Looking for help, I bought a 2018 T6 and have had the barn doors replaced with a tailgate. However..... the autoelectrician is struggling to get the correct feed for the tailgate handle. He tells me that a specific feed is required to be powered for just 10s or so and no matter how much he...
Free to collector. A1/A14 junction area, Cambs.
Full width barn door threshold cover.
Ideal for work van which often come with only a short protector piece.
Rough cosmetically, but would still do what it's supposed to.
Evening - Viewed a van today which looked decent. Only thing which concerned me was the left barn door didn't shut flush, it was flush at the top but stuck out about 5mm at the bottom. Is this an easy fix?
Hi, as the title suggests I need some really simple step by step instructions on how to shorten the barn door exterior handle locking rod. I couldn’t open the back doors at all, from the inside or from the outside.
After a lot of head scratching and taking the internal panel off, I managed to...
Does anyone have their original T6.1 2020 (barn doors) transporter badge still on the back? I've bought a black one to install and my chrome badge was on my grab handle.
Any pics I can go off?
Is this right?
Just gathering ideas on making the Alpine HCE-C2100RD camera fit in as much of OEM looking fashion to my T6 Barn door.
Anyone done anything similar with a OEM mount and maybe the use of Van-X's rear plinth
Hi there, no matter how much I search I can not find any information on this wiring issue.
I have a t6.1 barn door that I have fit a rail gate to.
The rear wiring has 6 wires on the drivers side and a 6 pin plug and the passenger 5 wires.
The tailgate rear lights both have only 5 pins inside...
The t5.1 van I purchased came installed with slam locks - very annoying if you intend to use the van as a camper. worse still the barn door and sliding door had different keys!
I spoke to the original makers of the locks and a vehicle locksmith but both were of no use. However I did find bits of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.