slider

Can i request anyone with a 6.1 can take a picture of the rear latch on the sliding door, im interested to know if they all have the silver plate on them (helpful to know if its highline/trendline etc) Also if your van has power latching and/or electric side door can i see a pic of the motor/van...

I know its been mentioned on the forum before, but I need help locating the part that goes into this hole on the sliding door trim. I wasnt going to bother, as last time the ply panel didnt have that slot, but this time they arrived with it cut out so I will need the cover that isnt there.

When it rains, the water is seeping into the door handle and leaking between the funnel and where it meets the sliding door. I’ve tried getting some sealant up there but isn’t easy to get fully sealed due to the location, any ideas? Not sure if replacing the handle will help as the seals seem...

Hello, I’m pretty new to the T6 so learning as I go. We seem to be having a lot of problems at the side door sometimes on unlocking the side door won’t open without actually climb in and in locket from the inside. Earlier today tried to shut the door antithesis wouldn’t engage in the lock to...

Hi, Can some one help me please.I am trying to buy a side door sliding roller (lower) nearside door for my right hand drive T6, i have tried to get one with no avail only offside ones PLEASE PLEASE HELP

Hi all, the light on the sliding door side step has never worked, (T6) I’ve change the bulb and no luck, how easy is the step to pull up to check the wiring? Has anyone else had this issue, any help would be great, thanks

Thought I would clean the van today and very disappointed to find rust spots under the sliding door roller cover trim ! Anyone else had this problem ? Van is a 2016 ! Cheers

I am having a nightmare today with the sliding door on my T6.1. Please forgive me as I am a knob when it comes to mechanics. It was fitted with a Loc8 table, but do not think that has caused the problem, but you never know. So, as far as I remember, the sliding door opened from the inside (and...

Hi guys. Has anyone experienced this fault and knows how to sort. My n/s slide door handle inner and outer is really stiff. The latch seems to be aligned door latch and when manually move catch over the handles are easy to use to release it. Door closes ok but wondering if the power latch...

Hi guys I have a panel at the rear of my van that has popped out slightly. Looking behind it there seems to be a plastic clip that has worn. Does anyone know the type of clip I need to replace or the name of this panel to search it up? Also any help on how to remove and refit would be appreciated.

My door handle on the sliding door not spring returning. I'm in the process of removing the inner trim so I can gain access to it but I'm struggling to get it off and don't want to damage it. I've popped the clips at the bottom but cant get any further. Do I need to remove the trim around the...

Hi all, recently encountered a problem where my interior light stays on when I shut my doors and the side repeaters don’t flash as I lock the van, I’m hoping there is an easy fix as it’s frustrating me lots lol many thanks

Had a problem with the sliding door not opening, so i took out the mechanism, applied some WD40 & that seemed to solve the problem. However since putting it all back together, the door locks & unlocks fine, but the door is showing as open on the dashboard & the picture of the van with the door...

Afternoon Volksfriends, I hope you're all keeping well. I'm not having much luck with my T6.1 so far. On day 1, the barn door opening mechanism failed. A month in, the front drivers window started leaking like a sieve. Now I've got water coming in through the top of the sliding door past the...

Hi all, I'm having no luck. I've searched everywhere and asked on multiple forums/pages. My left hand side sliding rear door just won't open. I've been advised that it's most likely the actuator and I'm more than happy to have a go at replacing it myself but all signs point to the door...

I've done some searching but can't find anyone who has attached a table rail to the inside of a sliding door? I would ideally like to try and use the Mito table rail but would it hit the side of the van when opened? Has anyone experimented with this? I've a twin slider so am a little stuck.

Hi all My mate has found this rolling around in the back of his new pv Part number 7LA843959A Had a good look on google with no luck!! any ideas all thanks nick

I have a 2018 T6, I was putting some stuff inside today, finished what I was doing and tried to close the door, it will slide closed, but the latch doesn’t seem to be working properl and the door just opens again, at the moment I have some cord holding it closed, but it’s not closed properly...

Anyone had any issues with the clips securing their loc 8 tables? Bought some aftermarket ones which popped off then bought some oem ones costing 10 times as much and they did the same.as soon as the door closes they either pop off or start to work their way out.seems they dont hold the table...

Hello all, odd one, driver side side loading door handle has gone sort of floppy? Has anyone else had this and possibly how did you fix it / what was needed.... Thanks in advance Nick