wheel arches

Hello all, has anybody tried fitting a set of wheel arch protectors of a wheel arch that has had Silent coat / Deadmat 2mm applied? Thinking it might good to sound deaden the arch but I don't want a carpet covering.. many thanks.

I have bought a T6 van and noticed that the nearside front wheel has a bigger gap at the front than at the rear inside the arch. Front gap is around 10cm's and the rear gap is around 6.5cm's On the Drivers side, Front gap is around 8.5cm's and rear gap around 8.5cm's. I wanted to ask what...

Hi all, just wondering if anyone has any pics of their wheel arches that have been squashed down to accommodate their Cali seat. At the moment I can lift the bum seat to slide back but would prefer to do this without lifting. Any help as always is appreciated.

Hi guys I want to remove the jack holder before carpeting. I don't have a grinder can I just drill out the 3 spot welds?

Fitted Stance + Ultra. I am very happy with the ride and handling but the road noise seems much louder?. I am running 20" with 275/45/20 tyres and still have 50mm freed left on the strut but am still rubbing on bumps. I don't want to left the van any higher as am very happy with the look. Any...

I've just noticed my carpet lining on the inside of my sliding door rubs against the side panel and wheel arch when opening. I tried adjusting the bottom 2x m8 spline bolts which helped a bit but still not quite enough. Is there anything else i can do? Thanks in advance

In the n/s arch lining, the fog light cover hole access thingy magiggy is missing. Can't figure out what's it's called so I can buy a new one. Anyone have a part number?

While fitting wheel spacers (25mm) this weekend, I took the opportunity to also remove the wheel arch liners and stick Silent Coat to the wheel arches for improved sound proofing. After doing so, I then became concerned that I have perhaps introduced a moisture trap to the underside of my van...

Hello all on t6forum. Recently bought a used t6 Kombi (& love it) with cotrim lining in the back - link below shows on their website (ABS lining bottom right pic) Transporter Kombi Looks great but when opening side sliding door the small (hard plastic) pocket on the left scratches the wheel...

Hi Guys, I'm running a vanshades built in table and when the sliding door is open it's very close to hitting the rear arch. If opened quick enough it may even touch a bit. I'm going for a swamper look soon and planning oem plastic arches. I have a feeling it's definetly gonna touch. Can the...

Hi, My lining carpet has arrived from Mega Van Mats today, I've read the guide but I can't tell whether it is recommending to do the wheel arches as part of the one piece used for the side, or to do it with a separate piece. Any suggestions?

Got a bit of time to get a step closer to finishing the interior of my kombi. Wheel arch boxes are constructed and speakers fitted. This evening I have made the top mounting supports and bonded them to the wheel arch as well as bonding the lower box fixing ply rail to the sides of the wheel...

Hey, does anyone know where you can buy the interior wheel arch boxes for a T6 Kombi with twin sliding doors? Vanstlye do them but only for single sliders and there isn't enough room in between the cover and the wheel arch to apply silent coat and foam. Ideally what I want to do is rip the...

Got a problem with both my sliding doors. Just as the door gets to the end of the runner, as it clips in to the end stop the electric opener seems to pull/push it into the arch, when it's clipped in there is about a 5mm gap. If I open the doors manually then it doesn't happen. Both my arches...