Customising DSG gear lever selector & gaiter

Anyone know if there’s such a thing as a reflected surround? So the selections are actually visible where you’re driving??
 
Well, the obvious mistake was now annoying me. That'll learn me for pilfering the blue LEDs.
20201116_210305_resized.jpg

I had to do it all again. I took the blue LEDs off again with the reflow machine, but didn't have any red LEDs in the factory to replace them with. I didn't fancy pulling them off with an iron, after scrapping a very valuable OC768 card back in the day ham-fistedly trying to pull off SMDs with a Weller soldering iron......:rolleyes:

20201116_211358_resized.jpg

I bough a strip of ultrabright red SMD LEDs from the 'Bay and put them on with the chisel sized Weller in my garage....

20201116_212304_resized.jpg

Slightly wonkey donkey, but it was by hand with solder and no paste.


That's better.....
20201116_212555_resized.jpg


All this effort, but calm is restored.....

20201116_212549_resized.jpg
 
Got the gaitor changed thanks to this thread!

But clearly the gaitor assembly is not intended to be taken to parts, this was at least close to the most annoying job I’ve touched.

IMG_3557.jpeg

I also changed the leds to red on the same go

IMG_3552.png

… with a permanent marker :whistle:
 
Last edited:
Sorry what I mean is how do I remove the whole sag gear knob gaiter assembler as one?
Did you manage to fix this? We’ve got an over-inquisitive 5 year old who’s taken ours out for us and now we can’t get it to ‘latch’ either… Thanks
 
Is it still possible to view this please? Not sure if I’m not doing something right or it’s just no longer available. Thanks.
Hi. You need to upgrade your membership to VIP in order to access the download section of the forum. :thumbsup:
 
Back
Top