Eibach lift balance springs.

Grainfoot

Member
T6 Pro
Recently had a set of Eibach lift balance sprigs fitted by Dav-Tec to our heavy camper .
What a difference. Was hoping to get a bit of lift at rear to prevent tow bar catching on rough uneven ground and to level van a bit. They have done that but also the ride is a lot lot better than the original springs.
For anyone with a rear end heavy van I can highly recommend these.
 
I've just had these fitted to mine.

Not only do they rerstore the ride height to original spec perfectly, the spring rate is very well suited to both the vehicle and the original dampers.

I was originally intending to go the budget route and slap in some T32 rear springs, but I'm glad I spent the extra and did it properly. It wasn't even that expensive. Very happy indeed.
 
I've just had these fitted to mine.

Not only do they rerstore the ride height to original spec perfectly, the spring rate is very well suited to both the vehicle and the original dampers.

I was originally intending to go the budget route and slap in some T32 rear springs, but I'm glad I spent the extra and did it properly. It wasn't even that expensive. Very happy indeed.
Another vote for the Eibach springs. My lwb 4motion t32 was sitting down at the rear with the permanent weight of the conversion so last year fitted the Eibach /Bilstein 35 mm lift kit which even with the adjusters on the lowest setting have set the van at the same ride height as an unloaded factory spec van . As above the ride quality is excellent. I think you would have been disappointed with the t32 springs so a good call.
 
Back
Top