Error: Start-stop, Error: ABS/Stabilisation control (ESC), Tyre Pressure Loss indicator currently not available

[studioviz]

Hi All,

I get the following error messages in order:
1. Tyre Pressure Loss indicator currently not available
2. Error: Start-stop
3. Error: ABS/Stabilisation control (ESC)

These messages all started flashing up a couple of weeks ago and then disappear after about 10mins. At first they were intermittent, every other journey. Now they flash up every journey.

Any idea what could be causing this and how it can be put right?

I’d really appreciate any help!

I’ve attached pics from the dashboard of the messages.

Cheers

 

[mtm77]

Likely to be a wheel speed sensor but you would need to read the fault codes to see which one

 

[chipshopmafia]

I have this exact problem at the moment. Did you get yours sorted @studioviz? What was the fault / remedy in the end?

 

[roadtripper]

All of those systems rely on the wheel speed sensors so highly likely to be one of those failing or the wiring to it.

To find out which one read the codes, it's much easier to get the van to tell you than trying to work it out by replacing them.

If you don't have one then Carista is a good choice for some one off diagnostics.

 

[studioviz]

So I ordered a cheap OBD2 reader to try and read the error codes for this. It turns out that the cheap OBD2 readers can't detect ABS related faults. My reader shows no error codes. Not sure where to go from here! ??