Lazer Lamps - wiring and fitting

[Unimog]

My van (2017) is fitted with factory fitted LED headlights.

I would like to instal Lazer spot lights. Is there a conventional high beam switch wire I can connect my relay to, or do I need to connect back to the Canbus?

thanks

 

[Alexzeat]

Hi to tall

i bought the Lazer Lamps 750 for T6 i dont know where i need to conecte the cable to the lights? someone know about it?

The instructions say it :

But i cant found the wire for the position ligths and headlight....

 

[Loz]

It will depend on which lights you have H4, H7 or LED?

 

[Alexzeat]

It will depend on which lights you have H4, H7 or LED?
View attachment 83569

I Have the H7, do you know where i can connect? THanks

 

[Deaky]

Main beam on RH headlight is available in the following places
White cable, Pin 1 of the black 73pin connector in the BCM
White cable, Pin 8 of the black 10pin connector on the headlight.

Main beam on LH headlight is available in the following places
Black/White cable, Pin 1 of the white 73pin connector in the BCM
Black/White cable, Pin 5 of the black 14pin connector near the horn
Black/White cable, Pin 8 of the black 10pin connector on the headlight.

 

[AttieP]

Please advise on the lcd setup

 

[mmi]

Please advise on the lcd setup

LED headlights?

T6 LED headlight retrofit?

Hi Pauly, Thank you

www.t6forum.com

 

[AttieP]

LED headlights?

T6 LED headlight retrofit?

Hi Pauly, Thank you

www.t6forum.com

Sorry yes LED Head Lights , Myne has LED's Headlights from Factory and would like to add the Extra Lazer Lamps so would need to know what wire to use for the High Beam,

 

[mmi]

Sorry yes LED Head Lights , Myne has LED's Headlights from Factory and would like to add the Extra Lazer Lamps so would need to know what wire to use for the High Beam,

Basically the same outputs on the BCM and wire colouring as above (RH-white; LH-white/black) which eventually surface at pins 11 (of 14 pin connector) on the headlights.

Detailed wiring diagram - look for terminal 56a

T6 - LED Headlight Circuit diagram

Fixed version of diagram

www.t6forum.com

 

[loadinglevelone]

What about the bulb fault detection system when hooking a relay into the high beam wire for H4/H7.
Will you run into error codes?

 

[dubber36]

No problems. The trigger for the relay is such a tiny draw that the van doesn't notice.

 

[loadinglevelone]

Good to know. Thx.