Please advise on Poweflex front bus installation

[Limalex]

Hello Gents.

I having some problems during the front bushing upgrades.

Rears ware super easy, but fronts seems need a bit of force.

I would need some advice from those already installed the adjustable Powerflex bushes to the front.

It seams they not in line with the fitting location and I am not sure if I should try forcing them in place.

Both adjusters are at the outside

 

[Sasquatch]

Assuming everything is in the right place and in the correct order, you may need to partially insert on into position and then persuade the others with a rubber mallet.

As an aside, they look very clean - did you use the supplied lube when assembling them?

 

[Limalex]

Yes all fitted correctly grease applied as well, but not on the outside yet. I just wanted to make sure about the correct fitting

 

[Pewt]

I fitted non adjustable one with no issues, not got around to doing the rear yet.

Just curious why you are fitting adjustable on the front as they are not really needed to get the alignment in tolerance.

 

[Limalex]

I fitted non adjustable one with no issues, not got around to doing the rear yet.

Just curious why you are fitting adjustable on the front as they are not really needed to get the alignment in tolerance.

I might go lower later on .Who knows?