Tyres wear on inner edge

[HHO]

I had VW Stratford sort mine out. They referred mine to the Audi dealer next door - set mine up using the Hunter system they use for the Audi R8 due to the wheelbase so they said. Any main dealer who use Hunter should have a couple of senior technicians who can use it. Wheel balance weights put on with OCD precision too!

 

[former member]

BMW insists on "KDS alignment" which is the same as Hunter but about £250+.

Those with any car knowledge and a BM use a decent tyre fitter and get Huntered.

 

[HHO]

Mine was £49.95. Audi main dealer for Hunter.

 

[T6180]

so if I'm reading this right ...if your van is lowered this will cause positive camber and this can't be adjusted?

 

[Foofighter25]

Hi all

My front tyres have covered around 10k miles and and they are worn out on just the inner edges. The drivers side is worse than the passenger side. The van has 20 inch wheels with 245/45/20 tyres and has been lowered 50mm I think. Was already lowered when purchased. The van drives nice and straight with no pull to left or right at all. Attached picture is the drivers side.
The tyres are Accelara Phi load rated. (Budget)

Any Ideas?

 

[VWDAZ71]

Looks like a simple case of just getting the tracking done. (And 2 new tyres)
But maybe other suspension work might be needed.

 

[Bigsidavies]

I had the same. Get a good hunter alignment done and it’ll be good.

 

[RobertO2023]

Alignment! Lowered / bigger wheels can be set within the geometry parameters