Vans gone in for the MoT so here is a little roundup of Saturday to now:
Front Magcode and DEFA EHU.

Fitted a cable from Aliexpress to make the stop start button remember what it was set to last time …..

….. and fitted this USB port (needs adjusting to link the backlight to one of the other switches and not be permenantly on)

Finally I’ve made squishy TPU replacements for the foam bungs that go in the doors around the mirror cables …….




I haven’t needed to pull one out yet, right one (marked T6 A) has the wedge piece a little smaller than the left one which was a bit of a struggle to push in …..
Posting from the phone, I’ll pop the STLs and link for the Tinkercad model (in case anyone else wants a crack at 3D printing some) when I get back to a desk
EtA - 3D design VW T6 7E0941913 Clone - Tinkercad - if you want to have a go yourself. STLs are attached, rename from .txt to .stl to use them
Front Magcode and DEFA EHU.

Fitted a cable from Aliexpress to make the stop start button remember what it was set to last time …..

….. and fitted this USB port (needs adjusting to link the backlight to one of the other switches and not be permenantly on)

Finally I’ve made squishy TPU replacements for the foam bungs that go in the doors around the mirror cables …….




I haven’t needed to pull one out yet, right one (marked T6 A) has the wedge piece a little smaller than the left one which was a bit of a struggle to push in …..
Posting from the phone, I’ll pop the STLs and link for the Tinkercad model (in case anyone else wants a crack at 3D printing some) when I get back to a desk

EtA - 3D design VW T6 7E0941913 Clone - Tinkercad - if you want to have a go yourself. STLs are attached, rename from .txt to .stl to use them
Attachments
Last edited: