I have just attempted a DIY wrap job to my T6.1. It didn't go too well, managed two goes at it and somehow it was worse on the second attempt. The wrap has lots of crease marks and bubbles. It took so long that by the end of it the wrap wasn't workable anymore. There are a couple of small tears...
Hi Everyone,
I thought I would pop some pictures up of my half wrap that I've recently had done by go4detailz (I'm not affiliated in anyway). They did and excellent job and Vadim is a complete perfectionist.
The van was with them for a week, I got some photo updates during the work and Vadim...
Hi, does anyone have recommendations for vehicle wrap companies in the midlands or south east, also what’s the going rate for a T6 full wrap.
Cheers
GB
...far too much time removing a failed solar panel from my pop top roof I decided to follow forum advice and bond its replacement to some 3M wrap.
I used Soudaflex to bond my new panel to a gloss 3m 2080 wrap, though I noticed that my panel had lifted away from the gloss vinyl after a number of...
We are about to sell our T5.1 Camper to fund a new bus. It has a bright green wrap on the bottom half that was done 2 1/2 years ago that needs a couple of areas sorted out on the barn doors and rear bumper.
What's the concensus; have the wrap repaired? Or have it removed and polished back up again?
Here is my new T6.1 after partial vinyl wrap last week. I bought it used and it came with the ply bed and storage which is great. I used to keep bikes inside my old T5 but will be getting a tow hitch carrier to keep muddy wheels outside!
We are about to get a new candy white t6.1 converted. Have been reading the forums about wrapping vs painting lower half.
Guess down to personal choice
Just wondered if any recommended companies reasonably close to Liverpool that others have used and would recommend?
I’ve had two recent quotes for a lower wrap on our SWB startline van, so not having the front and back bumpers wrapped, using a plain gloss colour £1200 and £1300, no idea if this is the average, I guess so as fairly close…
Looking at previous post re "wrapping silver bits" I've got shiny steel side bars on my SWB, and I'm thinking is it poss (and potentially cheaper than buying black replacements) to wrap these blingy bits?!
I don’t know what ‘appropriate condition’ means.
Am I correct to doubt if a clear wrap would hide imperfections, better going for
Black etc? If wrap is route
With poptop or not?
Van insulated?
Front screen wrap?
What type of bed have you got.
You have a diesel heater?.
......
We just use layers.....
Starting vith PJs.
Then a duvet,
Then various over fleece blankets.
And a fleece blanket underneath too.
We have no poptop, but van panels and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.