40mm springs

Hi, I have a 2016 T28 T6 with 40mm lowered suspension. The ride in the rear is really uncomfortable and every bump sends a shudder through the van. I've taken a look at the springs to see if i can identify them and notice the coils are really compressed. Would this normally be expected?

I have lowered my T6 on H&R 40mm springs and original dampers, now and again I get a twang with the spring moving, ideally I would like to put new shorter shocks on, what is everyone using I want them to be affordable and decent?

Hello, I have for sale some H&R -40mm springs code 29270-2, £100 seems to be the going rate on here. Would prefer collection (RH16) due to weight but could post if buy covers the cost. Advertised elsewhere. Cheers

Hello all, It seems I keep ruining my van. I had some new H & R Springs fitted with a 40mm drop. These were done by a local garage, who have seen my van for the last time. Has anyone experienced this noise before. Thanks

Hi all Having a bit of a clearcut of the garage and have a few things for sale. I have a set of H and R 40mm lowering springs. Took them off my T6 t30 in October 2019- my T6 is a 2018. I don't know if they were just fitted before I bought the van in August 2018 but the springs are like new...

Hi all, I’ve been worried about my saggy arse for a while (I’m at that age!!) so after reading on here I decided the solution was to put some T32 springs on there thinking the original springs must still be in place. Anyway I decided to look under the van to check and the springs are actually...

I’ve a set of T32 Cobra 40mm sports lowering springs for sale, they’ve only done 8000 miles. Fitted by Leighton vans in late 2018. £178 when new. Make me an offer. I’m just north of Dundee, they weigh 20kg so post would be roughly £35.

Gone the coilover route so I no longer need the shocks/springs. Springs are H&R 40mm lowering and covered about 9k miles. Shocks are standard VW T32 which have covered 20k, perfect working order no leaks, knocking etc. Shocks & springs £150 or springs only £100.

Anyone fitted 18” inch sportline alloys with 235 55 R18 general grabber AT3’s Will they work if it’s lowered 40mm

Hi all, Had 40mm H&R springs fitted and went for 19” wheels. Driven for a few hundred mile to settle but still think it’s sitting too high (especially at the rear), any advice or pics of yours with similar set up please..

Just had the Eibach Sport Comfort 35-40mm lowering springs fitted to our T6 T28 camper as it had the 'high at the front' syndrome. Big improvement in handling on the drive home, and the van now sits level. It's not noticeably lower at the back, and I didn't want it to be - just wanted it level...

I have for sale a set of four Koni Special Active shocks, these are for the T28/T30 fitment and they will not fit a T32. They are suitable for vans lowered up to 40mm. Bought from CRS Performance in June of this year and used on my van for around 4k miles. These shocks give a superb ride, I only...

£125. Load rated for T32. Used on the van for 12 months so have a bit of rust on them as can be seen in the photos. Collection from Huddersfield or can post for additional cost, should be £10-£20 depending on location.

Ok you fantastic lot, here goes: T32 LWB T6 150kw, big brakes, on 17" Devonports. I have just had Koni Actives and -40 drop fitted today by @CRS Performance. Fancy some 18" or preferably 19" alloys staggered if possible, what can I fit width wise? I have twin slide doors so want them rears to...

Hi guys, selling these cobra lowering springs. I done about 2k gentle miles on them before I ditched the 20’s and went swamper. I also have an original set of T32 rear springs if anyone is interested, they came off a van with 3k miles on it. In Glasgow and open to offers! Ps also got a black...

Hello, Looking to swap some 40MM H&R lowering springs for some 50MM versions. On the off chance that someone doesn't like how low the 50's are. Located in South Lakes Thanks..

Genuine set of front and rear H&R lowering springs removed from my van yesterday by @CRS Performance. Steve at CRS described them as ‘as new’! The springs have covered less than 7000 miles and are -40mm lowering springs taken from my SWB T28 van, so would be a direct swap onto the same spec van...

Hi, after a bit of a trawl I can’t seem to find a great deal of discussion on these springs. Who has had them fitted and what’s the verdict? Review of 40mm drop on a T32 everything else factory standard wood be very useful. Anyone with a recent Leighton Van may have this setup I believe? Thanks...

Set of springs part number 29270-3 40mm drop, van has done approx 4K miles with them fitted but wanted to go lower now. £130 Collection preferred from BS22 but will try and help with postage if you research a cost your happy with.

Hi all. I’m clearing out my storage unit and have a few bits to sell off my T6 Highline which has now sold. The H&R 40mm lowering springs (29270-3) were on my van for approx 6000 miles until I changed to colorers. From Swanley/Dartford area. £100 Thanks Paul