VCDS Error code for antenna 2??

[korkykat]

Good evening everyone.

Have done a gateway scan and have this code popped up. It reflects why i have such a sketch DAB Signal

2016 7E Diesel

Does anyone know where i can locate voltage terminal 30. i have tried looking at the wiring diagram but now my brain is frazzeled

thanks

1 Fault Found:
0003 - Antenna 2 for radio
B111A 13 [009] - Open Circuit
Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 6
Reset counter: 252
Mileage: 73418 km
Date: 2022.02.21
Time: 16:39:59

Voltage terminal 30: 9.8 V

 

[Pauly]

terminal just refers to permanent 12v so its battery voltage, unless of course theres an issue between the battery and the point of measurement

As it says antenna 2 i would assume its the fm aerial as theres 2 of them, one in each wing mirror
I think the aerials are shown on the stereo/infotainment section of the wiring diagrams

 

[Pauly]

Actually it has its own diagram

T6 - Aerials Wiring Diagram

Aerials In Exterior Mirror Circuit Diagram Shows AM/FM/DAB/GPS/GSM aerials VIP Membership is required to download this document

www.t6forum.com

 

[Pauly]

You can see on there it shows aerial 2 as the FM aerial in the right wing mirror so i assume its that one
note DAB is a separate antenna

 

[korkykat]

many thanks for that, at last i can see aeril 2 location which is R93

Its says "open circuit" so does that mean a break in the wire and if there is a terminal 30, i dont seem to see it on the drawings??

 

[Cool Carlos]

@korkykat did you manage to sort out the Open Circuit problem as I have the same error appearing?

 

[korkykat]

sorry for the late reply but cleared it multiple times but still returns. how about you