Search results for query: water ingress

I see Hilo/Horizon now has 60Kg roof loading, which would put it back on my list. I was picking mine in Autumn 2022, so not the right time to be going Hilo.

...with a VW specialist and he has recommended that I replace the micro-switch on the drivers door lock as well, as they can be prone to water ingress. Just wanted to ask the question what's the thoughts? As I am still really concerned that the windows could open again, weather or theft...

Rear Level Sensor loom redone in correct colour cable and correct seals Before At last it’s done properly now and hopefully won’t have water ingress for a third time!

...do what I did and remove all the tailgate trims :rolleyes: The seal leaks, bur the OE part has been upgraded. As a temporary measure, I used heavyweight clear tape over the light to reduce water ingress. Also remove the 4 plastic bungs from the bottom of the tailgate to allow the water to drain.

...end. Put a smear of Sikaflex 221 under the top 'clamp' and behind the lower flange. This stops shifting and creaking, and prevents water ingress via bolt holes. I'll let the Sika cure for 48hrs then mount the spare. Mine is on 18s and the spare is still a 16, so when I get back from next...

...too. You can remove the unit and remove the blue microswitch from the rear and probably see like mine that there is corrosion from water ingress. I've just removed mine but not yet ordered a replacement as everything on ebay looks like copy chinese stuff. the blue microswitch is the same...

This is a very good and thoughtful query. If they are attached via the standard roof holes there is a risk of water ingress, as with anything bolted on there. Did you see prior to fitting if the foot sections of the roof bar kit have a rubber gasket or pad that snugly and completely covers the...

Evening All, So I was driving my van back from getting the sliding door module replaced following water ingress from a leaky rear quarter window. Stopped at a petrol station, filled up with diesel and went to restart the van and the following error code came up. Couldn't start the van, called...

...connectors in question and apply a little bit of grease to electrical contacts on the "socket" side and replug it together. Any future water ingress will not cause contact corrosion and chances of disturbing electrical continuity are going to be seriously minimised. Please post adaptation...

Micro switch water ingress. Used to have Ford's that did this too, caused by power washing

The tank has to be vented at the highest point. This to allow the air out when filling and to allow air in when consuming water. I have two vents in case I’m parked on a hill, 4mm bore is plenty, stick a cheap, generic disposable fuel filter on the end of the vent tubes to prevent ingress of...

The sliding door rail and the sliding door rail cover panel are both prime locations for rainwater ingress. With the rail, the rain water gets behind the foam gasket for the rail end then seeps past the bolt and into your van. With the sliding door rail cover panel, the fastening clips which...

OEM plugs. Come with those in as new.

...collecting there. Now I am parking the other way and no water can collect. Rather bad design to be honest and wonder will there be a water ingress when going on a wet road, but as you have also noticed there is no bottom rubber seal on doors anyway. Drove an MOD Ford crew cab last weekend...

Hi, I took mine to VW and they did a ‘water ingress test’ (put it under a hose for a few hours) and confirmed there was a leak. They’ve said it’s a door seal that’s the problem and they’re ordering me a new seal in. Once it’s fitted and it rains again I’ll report back as to whether this is the...

Thank you so much I’ll have a look at them once it dries up. Appreciate all the support have a great weekend 👍

Not sure which roofs have a vinyl canvas, but the Hilo has a high quality, marine-grade canvas. Not sure if that's the same as water-proofed. but never had any water ingress. My bad for not reading thread the entire thread. :whistle:

If by fitting them you caused the water ingress that resulted in the short then yes. It's not a matter of avoiding the warranty, the warranty doesn't cover damage you caused even if unwittingly. It's insurance against manufacturing faults not accidental damage. If you've gone back to stock then...

...every time I put the van in reverse I get no signal I'm starting to loose my mind as my camera worked fine for two years prior this event with occasional camera swap out due to water ingress I also have just tried a power relay and still no luck and the headunit is new also. Any help...

I am sure I have see this discussion before here on the forum. If I remember correctly water ingress on the slider is quite common. Coming in from the rear latch area. Or from the leaky window, water dripping through the slider panel to the bottom resulting in damp in the area you have...