Cerbo GX
- Thread starter The Flying Scotsman
- Start date
That's a proper set up!Think I will need your help when it arrives.
Most of the new equipment will be mounted on that board that will live beside the LB.
The victron MPPT is going where the existing solar controller is in the rear cupboard beside the Sargent.
But it’s easy to run cables from here to the LB.
I’m retaining the Sargent for the fuses for the whole 12v system but I will disable the charger on it and fit the victron one I’ve bought.
The victron charger will be hard wired and I will just need to plug the cable from it into a socket to charge the LB when on EHU.
I’m also hard wiring the EcoFlow 800w charger in there to quick charge my Delta 2.
The 2 cables from these will be clipped up and easy accessed from the main cupboard below my sink.
I’m installing a sub and amp under my drivers seat too as well as my reverse camera.
I can’t wait to get it all fitted.
A banging off grid set up with the 360w victron solar panel.
With 230Ah (250Ah?), a 50a DC-DC, 360w of solar and a separate delta I doubt you'll have much need for EHU. So long as you've got a spot with not much shade, you could be off grid for a week, quite easily.
So I need 2 sets of these cables Paul?
One set for Orion and one for MPPT?
No Gord, just one for each device. Available in different lengths.
2 cables, one for the MPPT and one for the Orion. Check what length you need based on where the Cerbo will go.
That’s my credit card glowing hot again 
I’m holding this forum and mainly Paul responsible for this although Wayne’s awfy good at spending my money too
Cerbo GX not the S is on its way and so is the 50 screen.
I can’t see me ever using the additional tank and temp ports on the GX but it was only £15 dearer than the S and knowing what I’m like I thought the extra £15 was the way to go.
I’m going to wait until it arrives before moving all the bits on my panel to accommodate it.
Once I’m happy with its position I will measure distances to get the correct length cables to hook it up.
I will wait and order the roamer battery cable also.
I’m going to spend some time on my install today.
Main job is running a new 16mm cable from my SB to the LB
I’m holding this forum and mainly Paul responsible for this although Wayne’s awfy good at spending my money too
Cerbo GX not the S is on its way and so is the 50 screen.
I can’t see me ever using the additional tank and temp ports on the GX but it was only £15 dearer than the S and knowing what I’m like I thought the extra £15 was the way to go.
I’m going to wait until it arrives before moving all the bits on my panel to accommodate it.
Once I’m happy with its position I will measure distances to get the correct length cables to hook it up.
I will wait and order the roamer battery cable also.
I’m going to spend some time on my install today.
Main job is running a new 16mm cable from my SB to the LB
I feel i'll be shortly behind you on this once I've done some reading up on it and figuring out what I needThat’s my credit card glowing hot again
I’m holding this forum and mainly Paul responsible for this although Wayne’s awfy good at spending my money too
Cerbo GX not the S is on its way and so is the 50 screen.
I can’t see me ever using the additional tank and temp ports on the GX but it was only £15 dearer than the S and knowing what I’m like I thought the extra £15 was the way to go.
I’m going to wait until it arrives before moving all the bits on my panel to accommodate it.
Once I’m happy with its position I will measure distances to get the correct length cables to hook it up.
I will wait and order the roamer battery cable also.
I’m going to spend some time on my install today.
Main job is running a new 16mm cable from my SB to the LB
This thread should probably come with a warning.
How much did you pay for the Cerba GX? Found it for £165 + £7 deliveryThat’s my credit card glowing hot again
I’m holding this forum and mainly Paul responsible for this although Wayne’s awfy good at spending my money too
Cerbo GX not the S is on its way and so is the 50 screen.
I can’t see me ever using the additional tank and temp ports on the GX but it was only £15 dearer than the S and knowing what I’m like I thought the extra £15 was the way to go.
I’m going to wait until it arrives before moving all the bits on my panel to accommodate it.
Once I’m happy with its position I will measure distances to get the correct length cables to hook it up.
I will wait and order the roamer battery cable also.
I’m going to spend some time on my install today.
Main job is running a new 16mm cable from my SB to the LB
SALE - Victron Cerbo GX - System controller
www.bimblesolar.com
The bastards.How much did you pay for the Cerba GX? Found it for £165 + £7 delivery
SALE - Victron Cerbo GX - System controller
That’s exactly where I just bought mine from but at £175 plus £7 delivery
Really happy with mine. And yes it's @Drive Wayne bloody fault for changing his! And I have the relays on the Cerbo controlling my interior and awning lights from the app. Very funky!!
My error, just realised mine is the MK1. MK2 is £175The bastards.
That’s exactly where I just bought mine from but at £175 plus £7 delivery
Paul, I have a Fogstar too so do I need this 'shunt'? Possible link to one if so?
Which is the link cable please Matt? Is that the VE cable? I have two of those so far
Similar threads
