Need a software update, but might sort itself out, did you fill to the indicted maximum, or did you brim it?
How does one go about getting a software update? I think I have the same problem with my van (intermittent adblue fault), but when I called VW to ask if they could update the adblue system software when I bring the van in for a service they said they'd only update if it was part of a recall and there weren't any outstanding on my van. They said they could do a diagnostic which would be £180 straight away, no thanks...
Is it only VW who can do updates through ODIS? or can reputable tuners do them as well? I was thinking of getting a remap anyway so could be done at the same time?
Sorry to hijack Kev63 - glad yours is ok again!
VCDS log:
Address 01: Engine (2D2D2-CXHA) Labels:. 04L-907-309-V2.clb
Part No SW: 04L 906 056 KG HW: 04L 907 445
Component: R4 2.0l TDI H02 3771
Revision: 23002001
Coding: 00254014432401090000
Shop #: WSC 02739 790 50316
ASAM Dataset: EV_ECM20TDI03004L906056KG 004004
ROD: EV_ECM20TDI03004L906056KE_004.rod
VCID: 7CA1F95C866E9D7BBBB-8028
VINID: 9E606AAAA1D8A9A60014204724B8EAFDBB
4 Faults Found:
33262 - Reductant System Performance Bank 1
P204F 00 [096] - Malfunction
Intermittent - Not Confirmed - Tested Since Memory Clear
31103 - SCR NOx Catalyst Bank 1
P20EE 00 [104] - Efficiency too Low
Intermittent - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 5
Mileage: 116673 km
Date: 2055.01.27
Time: 04:55:45
Engine RPM: 2029.25 /min
Normed load value: 75.7 %
Vehicle speed: 112 km/h
Coolant temperature: 90 �C
Intake air temperature: 15 �C
Ambient air pressure: 1010 mbar
Voltage terminal 30: 13.281 V
Unlearning counter according OBD: 40
Air mass at air mass meter 1: 208.8 kg/h
Outside temperature sensor 1: B1: raw value: 13.0 �C
Mass airflow sensor 1 bank 1 airflow: raw value: 860.6 mg/stroke
Throttl.valve adapt. 1 bank 1: posit feedback - Actual value: 55.05 %
NOx sensor before SCR cat conv: offset correction factor: 0 ppm
NOx sensor after SCR cat conv: offset correction factor: 136 ppm
Reducing agent quality sensor: urea concentration: 0.00 %
Reducing agent quality sensor: raw temperature value: 0.0 �C
30540 - Throttle Position Sensor (G69)
P0121 00 [032] - Implausible Signal
Intermittent - Not Confirmed - Tested Since Memory Clear
16230 - Control Module for Instrument Cluster
U1019 00 [032] - Missing Signal for Oil Level/Temperature
[Instrument cluster control moduleMissing signal oil level/temperature]
Intermittent - Not Confirmed - Tested Since Memory Clear