eBay. This is the one I used Silicone Wire Flexible Battery Cable 10 12 14 16 18 20 22 24 26 28 AWG Red Black | eBay
What Have You Done To Your Van Today?
- Thread starter Daneeyre
- Start date
-
- Tags
- mod modification mods retrofit
Hi, it’s not a pre-made LED, but a super bright 3mm LED and resistor. You then have to carefully drill out/pick out the silicone and LED resistor combo. Make up the new one and heatshrink it to insulate and protect, silicone or hot glue it in to the bezel, then add some loom tape and splice it in to the original plug.
ok thanks, what gauge did you use? sorry im not electrical..! i have the same panel as you do.. and same controller.. my cables have to pass in the B column so if i could find more flexible that would be great!
Last edited:
I've used 10AWG. IT's very flexible and much easier to route than the stiffer cable I used the first time.
A klingon cloaking device?
Easier to get a somebody else's problem field, cloaking takes more power than most of our batteries have
Finished fitting me abelmail charger, leisure battery and 240v setup. All tested and working properly.
Well chuffed. Thanks to @travelvolts
Well chuffed. Thanks to @travelvolts
Last edited by a moderator:
Where's your van gone?
I swopped mt dash part for a dipped version, and took an idea from another member, thanks @Timr for the idea
and fiited a couple of usb outlets for passengers phones. I also nicked the ever handsomes @Fish idea and fitted a engin cover and battery cover that I had dipped, just forgot to take a picture!
Last edited:
Tanzi
New Member
When you take the bumper off there is actually markings already on the back off bumper so no measurements required
You need to share the picture of your engine coverView attachment 43315
I swopped mt dash part for a dipped version, and took an idea from another member, thanks @Timr for the idea
